KickRom-Flash 4x Flash Rom adapter (27C400 emulator) v1/2

The KickRom-Flash Adapter (version 1.4 (pic 2,3) - 2.0 (pic 1,4)) is a programmable Flash-Rom replacement for EPROM devices (for example 27c400) or Kickstart-Roms in the Amiga computer. Up to 4 Kickstarts (512 kb each) can be loaded onto one brick and switched via jumpers or a toggle switch or via Langley Adapter (available separately). Programming and deleting the blocks can be done with the programming device KickRom-Progger (available separately) or an adapter (available separately) for common burners (e.g. Batronix). The devices can also be flashed by us beforehand as a service (selectable above). The special feature of version 2 is that the respective active bank is also indicated via the LED display on the top.

Note: Please note that all points described here only apply to revision 1.4 - 2.0. All previously delivered revisions were pre-releases and cannot be programmed via your own programming device without further ado.

Features

• Fits all Amigas (own version for the Amiga 600 is available picture 3, selectable above)
• Holds up to 4 Kickstart roms on one chip
• Switchable via jumpers or an optional rotary switch as well as on the A1200 via Langley
• Rome covers for labelling can be printed as a 3D model yourself.
• New in V2: Active bank is indicated by an LED display on the top.

System requirements

• Amiga with socketed rom bank(s)
• Attention: Currently a separate version must be ordered for the Amiga 600 (picture 3, selectable above)
• Amiga 500 Rev 5 also requires a ROM adapter for Amiga 500 Rev 5

Included

• 4-way Kickstart Flash-Rom adapter (27C400 emulator) 1.x or  2.0 (selectable above)
• 2 jumpers
• Manual
• Optional: 4-position rotary switch
• Optional: Switching via Langley on the A1200
• Optional: Burning service for e.g. Kickstart - Data for programming must be supplied by the customer (selectable above)

2 years warranty

References

Hardware design: https://gitlab.com/rwahler1/kicad/Amiga_27C400_Emulator_Adapter.git