KickRom-Flash 4x Flash Rom adapter (27C400 emulator)

The KickRom-Flash Adapter (version 1.4) is a programmable Flash-Rom replacement for EPROM devices (for example 27c400) or Kickstart-Roms in the Amiga computer. Up to 4 Kickstarts (512 kb each) can be loaded onto one brick and switched via jumpers or a toggle switch (available soon separately). Programming and deleting the blocks can be done with the programming device KickRom-Progger (available separately) or an adapter (available separately soon) for common burners (e.g. Batronix). The devices can also be flashed by us beforehand as a service (selectable above).

Note: Please note that all points described here only apply to revision 1.4. All previously delivered revisions were pre-releases and cannot be programmed via your own programming device without further ado.

Features

• Fits all Amigas (own version for the Amiga 600 is available, selectable above)
• Holds up to 4 Kickstart roms on one chip
• Switchable via jumpers or an optional rotary switch (available separately soon)

System requirements

• Amiga with socketed rom bank(s)
• Attention: Currently a separate version must be ordered for the Amiga 600 (picture 2 and 6, selectable above)

Included

• 4-way Kickstart Flash-Rom adapter (27C400 emulator)
• 2 jumpers
• Manual
• Optional: 4-position rotary switch (sold separately soon)
• Optional: Burning service for e.g. Kickstart (selectable above)

2 years warranty

References

Hardware design: https://gitlab.com/rwahler1/kicad/Amiga_27C400_Emulator_Adapter.git