The RGB4ALL (v1.1) is a universal video converter based on the AD724 chip. It accepts the RGB signal at one input, encodes it and outputs it to composite video or S-Video sockets. This makes it easier to use the Amiga 500, 600 and 1200 on a modern TV or beamer set. Installation in a machine with NTSC is possible, but requires a new crystal oscillator to be soldered in (included).
Amiga with NTSC:
Please remember to put the SJ1 soldering iron in the correct position when using NTSC mode.
A PAL crystal oscillator is soldered on by default. Each module contains an NTSC crystal oscillator.
Please note:
This is fully assembled internal version.
Basic soldering skills are required.
Board requires six signals described as R, G, B, S, +5V, GND.
Please refer to your computer manual/schematics for exact soldering points.
+5V – Five Volt supply rail
GND – ground
R – RED
G – GREEN
B – BLUE
S – Sync
Package contains:
This Product was added to our catalogue on 21/03/2020.